36-Beam Non-Contact Ultrasonic Balancing Beam
Operating Instructions
Good Quality Comes From Specialty
Chapter 1 Controller Operation Instructions
This system is operated by Chinese and English menu, which is intuitive and convenient. Please read this manual instruction carefully before use.
1.1Power On
When the system is powered on, the display shall be as follows:
At the same time, all the LED lights are on. At this time, please check the situation of the LED lights. If any damaged LED lights are found, please contact the dealer in time. The display shall last for 1 second before the controller enters the working state.
1.2Workspace
After power-on, it will automatically find the installed CAN bus sensor. If the sensor found is consistent with the sensor used last time, it will automatically enter the workspace; if not, it will display the type of the new sensor installed.
Display Icon:
Post time: Jul-27-2021